While plumbing in attic space, you need to keep a few things in mind. One of the most important things to consider is insulating pipes in attic walls. Insulating your pipes in attic walls reduce heat loss and keep cold pipes from sweating during warm weather. Insulating pipes in attic walls is not any different than insulating other pipes in your home. 
The professional plumbers in Edmonton explain how you can improve your plumbing in attic space by insulating your pipes in attic walls. Here’s how you can insulate your pipes in attic walls:

Choose an Insulation
The first step to insulate your pipes in the attic is to choose the right type of insulation for them. Select a plastic foam, wood felt, or fiberglass material. The pipe insulation will have a slit on the top in order to allow it to cover up the pipe easily. You need to choose an insulation material that has a high R-value. The R- value is useful in measuring the efficiency of an insulator. For warm climates, you do not need an insulation with high R-value, but, for cold climates, a higher R-value would be necessary.

You need to purchase enough amount of insulation to cover all the pipes. You can measure the length of the pipes in attic walls in order to determine how much insulation will be needed.

Locate the Pipes
In order to measure the pipes and cover them, you will first need to locate the pipes in attic walls. In some of the houses, the pipes might run under a sub floor or at the bottom of the attic and for other houses, it could be located inside the walls or the roof rafters. Locating the pipes will also let you know if you will need a ladder to reach them or if you will have to work on your knees while installing the insulation.

Insulate the Pipes
Once you know where the pipes are located, you will have to take the insulation and cut it into small sections with the help of a utility knife to slide it easily over the pipes. You should open the insulation piece at the slit to slide it over the pipe. You have to continue this technique over the entire length of pipes inside your attic walls. To insulate the corner joints, you will have to cut a stimulated miter joint by cutting the insulation at a 45-degree angle. This way you will be able to slip the insulation over the corners of the pipe very easily.

When you’re done insulating the pipes inside attic walls, you should use duct tape to join any seams and secure it to the pipe. If you are unable to do this on your own, you can 
call professional plumbers in Edmonton who will insulate your pipes and keep all the worries related to your plumbing in attic space away.

Comments 0

Leave a Comment